roof section visible in interior elevations

[shamshirha]

I have a pitched roof with no drop down ceiling. In my interior elevations, revit shows a section view of the roof. Right now I'm just creating mask regions over the roof to cover the section details, but its getting tedious considering the number of interior elevations I have to do. Any suggestions?

Thank you in advance.

[JamesVan]

Do you want a single, angled line to depict the top of the wall in the interior elevation? If so, the masking region is the only way to do this in today's Revit. If you don't need the entire wall elevation, you could just drag the crop region below the roof.

[bclarch]

Use the linework tool to make the upper edge of the roof invisible. You will have to do it in every view but it is faster than filled regions.

[shamshirha]

thank you. I have to have an angled line depecting the top edge of interior roof. I will continue with my method or use the suggested invisible lines.

thank you for all your help.