toposurface - "shared" countours

[fstafek]

Hello everybody, is there any way for toposurface to show contours according to "shared" elevations, not to project one? I'm able to label them according to shared elevations, but they are on heights not common to "industry", we are used to "integer" like contour shared elevations...

Is it something I'm missing here?

Thanks for any hint,
regards Frantisek Stafek...

[Chad Smith]

If you are talking about the points that make up a topo, then no you can't change them to Shared. This is a problem Autodesk needs to address rather urgently.

For Contour Labels and Spot Elevations you can change the parameters to display either Project or Shared.

[fstafek]

If you are talking about the points that make up a topo, then no you can't change them to Shared. This is a problem Autodesk needs to address rather urgently.

For Contour Labels and Spot Elevations you can change the parameters to display either Project or Shared.

Thanks. I was talking about both :-) Fixed at least the second - via "site settings"

Thank you,
Frantisek Stafek