Building section visible in callout

[patricks]

I have 2 building sections through the middle of my building, each perpendicular to each other. When I open one building section, and place a callout of an exterior wall for a wall section, the perpendicular building section way over in the center of the building is showing up in my wall section. This is despite the fact that both the crop region and annotation crop are BOTH turned on. This makes my wall section appear way over the the far left and that other building section appear way over to the far right whenever I open the view. Anyone know why this might happen? I've never seen it do that before.

[Dimitri Harvalias]

Not sure if I totally understand the issue but check the Far Clip Offset of the offending view.

[patricks]

It was the same as the parent building section view.

So imagine this: you have a building section through the middle of a building. In that building section, there is another perpendicular building section near the center of the drawing. Now draw a callout wall section view around the exterior wall on the left side. The callout encompasses only the exterior wall. Now open that view, and it shows the enlarged exterior wall to the far left of the screen, with crop region around it, and then off in space to the right it shows a section mark for that perpendicular building section!

It's never happened to me before. I actually just deleted both building sections, re-created them, and then re-created the wall section callout and it was fine. I still don't know why it was happening, though.

[Dimitri Harvalias]

Another one to chalk up to the 'ghosts in the machine' :screwy: