start and end labels

[sturner]

is their a way to turn off the display of the start and end labels on the alignment plan view??

[MHultgren]

If you go into your Alignment Style and look at the Markers tab, you will see options for the Start Point, end Point and many more, Simply set the Marker to None and they will be turned off.

[sturner]

thanks for the reply Mark, but i want to turn off the label at the begining and end of the alignment. but still have on the PI and PT labels.

[sturner]

thanks for the reply Mark, but i want to turn off the label at the begining and end of the alignment. but still have on the PI and PT labels.

[MHultgren]

You can control each individual label in the dialog. There is an option for Alignment Start, End and geometry points, along with quite a few others. You can find these settings on the Marker Tab in your Alignment Style Properties.
(See the image below)

[Coolmo]

The markers you're refering to (in the picture) only change the display of the actual marker on the alignment (i.e. the little circles and such at the beginning and end). What Sturner's asking is how to permanently turn off the geometry point text at the begining and end of the alignment that says
EP=20+00.00 and BP=10+00.00 ... that nobody cares to see.

I've run into this too. We've set up a "no display" label style that gets rid of the individual label itself but it returns after I get back into the drawing.

[chadthomas]

If you don't want to see EP=20+00.00 and BP=10+00.00 just edit the alignment label start and end station for the geometry point label only. Change it to something like 19+99.00 and 10+01.00. That's a work around we've used.

[Coolmo]

If you don't want to see EP=20+00.00 and BP=10+00.00 just edit the alignment label start and end station for the geometry point label only. Change it to something like 19+99.00 and 10+01.00. That's a work around we've used.

Can you explain that procedure further? Are you changing the style? Are you clicking on the label itself?