Crosshatch material angle

[Anthony Miguel]

I have a floor plan with which has four diferent floor slabs, but the top material is always the same, i.e; ceramic tiles. The material setting is set to crosshatch 0.40m x 0.40m. I would like to change the angle of the crosshatch pattern individually on each slab (my outer walls don't form 90° angles so I would like to align the pattern to the wall of my choice). Is this possible in Revit?

[Anthony Miguel]

Sorry, I just answered my own question! I remembered that it was possible to rotate ceiling tiles. I tried the same thing on the floor material and it worked! I should have waited five minutes before posting my question.

[Dimitri Harvalias]

Remember that this will only work if the surface pattern is a model hatch pattern, not a drafting pattern.

[Anthony Miguel]

Thanks Dimitri, hadn't tumbled upon that yet!