Storefront Corner

[boofredlay]

I am inserting storefront in a brick on block wall, 4'-0" off the floor. 6'-0" high.
When I turn the corner, the brick does not seem to want to cut out.
I tried editing the wall joins and had to use mitre to get what is shown below. However I don't want any brick showing in the corner at all.

I have an L Corner Mullion 5x5 placed at the corner.

Any suggestions?

[bowlingbrad]

This is a known issue and has been around forever.

There are several 'workarounds' that can elieviate your issue.

You can use and in-place wall family as a void and cut the portions of wall out that are the problem.

You can offset your curtain panels to the exterior face of the wall (see the "similar threads" section at the bottom of this thread for a better explanation- the FIX thread).

[boofredlay]

I looked over the post regarding moving the storefront to the exterior face then offseting the mulls and panels. I could not get that to work as well.

The void however worked great. I only have one instance of this in my building so this is ideal.

Thanks.