Split rectangular ducts two directions in Revit?

[mrypdahl]

Does anyone have a rectangular duct split fitting (Not a wye)? Probably not too hard to create but thought I'd check here first.

Thanks!
Rip

[jbaumann]

Can you give us a screenshot of exactly the type of fitting your looking for?

[jshearon]

Was anyone able to find a solution to this issue? I have attached an image/pdf, can someone either create one for me or point me in the right direction? Thanks!

[tys90]

If you are using 2010 there is a split fitting. You can change the dimensions enough to get approximately what you want.