Sheet Codes

[dzatto]

Okay, this is for all you archies out there. I'm trying to renumber my sheets the "proper" way. Instead of A-1 for a floor plan, it should be A-101 right? A=architecural, 1=plan view and 01=first floor (or first sheet in the series). Here's the question (assuming that's correct).
What are the sheet codes?
1=plan
2= elevations
3= sections
4=??
5=details
6=schedules

Is there a 7, or 8, or............etc. etc.
OR
if I'm way off base, how do you number your sheets? Keep in mind I have archectural, structural, MEP and details. I was going to replace the A with an S, or an M, E, P, D....etc.

[stelthorst]

Hi Dan,

I'm no Archie either but this is how the Tri-Service CADD/GIS standard reads:

0. General (Symbols, Legend, Notes, etc)

Plans (Horizontal Views)
Elevations (Vertical Views)
Sections (Sectional Views)
Large Scale Plans (Plans, Elevations, or Sections that are not details)
Details
Schedules and Diagrams
User Defined
User Defined
3D Views (Isometrics, Perspectiives, Photographs)

[dzatto]

Once again, thanks Scott. I couldn't figure out what 4 was. Who'd of thought large scale plans. :?

[david_peterson]

Scott's sheet listing is also consistent with NCS. Just thought you'll should know.