Parameter value rounding up

[Lassep]

Hello all.
I'm having problems creating a functional repeating detail because the value in my parameret rounds up to 11.7 mm instead of staying at my needed 11.67 mm.

Is there any way I can change the unit decimal on the values in a parameter?

Lasse

[Lassep]

I figured it out myself :)

I changed the Project Units Format >shortkey:UN< to be rounding at 2 decimal places, and then I was able to use the 11.67mm in my parameter value.

To avoid the dimension to have 2 decimals, like 1120.00mm , I just edited my dimension style to not use project settings for units format, and used 0 decimal places for rounding. Then my dimensions were nice again without the .00 in the end :)

Hope this can help someone avoiding the same problem...