View Full Version : pitched walls
WYSIWYG
2007-11-13, 06:04 PM
How can I slope or pitch a wall at an angle? I am trying to clad a column and I want to start the cladding at the floor 2' out from the column and then meet the column father up. KWIM? If I were modeling a generic family I would use a reference plane but I can't seem to find how this works for a wall.
Thanks!
greg.mcdowell
2007-11-13, 11:25 PM
You'll need to either use a Mass and apply the Wall to the Face or an In Place Family. The first allows you to use Walls in the project... the second creates a Wall but with none of the components (just a solid mas).
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.