david.metcalf
2007-12-12, 07:05 PM
Good afternoon everyone,
I noticed here is no flanged "T" pipe fitting. There is a lateral "T" that swings from 45 degrees to 90 but then is offset from the center of the fitting. :cry:
What are we using to get a flanged "T" fitting into a project?
Thanks,
David
Edit: Just to let everyone know we were able to make one from a crossing flange but we are unable to make a reducing "T" where a pipe is smaller to one or the other side.
Thanx
I noticed here is no flanged "T" pipe fitting. There is a lateral "T" that swings from 45 degrees to 90 but then is offset from the center of the fitting. :cry:
What are we using to get a flanged "T" fitting into a project?
Thanks,
David
Edit: Just to let everyone know we were able to make one from a crossing flange but we are unable to make a reducing "T" where a pipe is smaller to one or the other side.
Thanx