jgratton
2007-12-21, 12:10 AM
I am doing exactly as the manual says. I installed sp1. My units are metric. The default vp properties are 1"=30' and I am trying to change them to 1:30. But it does not matter what I try to reset it, I get the error: "Invalid arguement Scale in setting Standard of Scale property."
I've attached a look at my scale list. I wanted to capture it before I try to reset it. I am not the only person with this problem and it is happening on all drawings made with out template, which was based on an autocad one.
Well, I'll be darned! That worked! I tried another template and that worked fine. Obviously a glitch in the template.
Is the scalelist saved in the drawing or in the registry?
I've attached a look at my scale list. I wanted to capture it before I try to reset it. I am not the only person with this problem and it is happening on all drawings made with out template, which was based on an autocad one.
Well, I'll be darned! That worked! I tried another template and that worked fine. Obviously a glitch in the template.
Is the scalelist saved in the drawing or in the registry?