ntnik
2008-01-03, 06:05 PM
i wanted to look at a square cut (not plumb) i have an example of each here. I want to understand what is it thats happening with the "two cut square"?......why is it picking that point to terminate the roof?
also, i want to do a scaloped edge profile on the porch rafter and see what that looks like. I could see this being accomplished easily by drawing over the model with lines. Is there anyway to model custom plofiled rafters....i guess just make a family floor based?
also, i want to do a scaloped edge profile on the porch rafter and see what that looks like. I could see this being accomplished easily by drawing over the model with lines. Is there anyway to model custom plofiled rafters....i guess just make a family floor based?