PDA

View Full Version : Profile layout tools unusable?


angie.comish
2008-01-09, 02:12 AM
Has anyone ever had their profile layout tab or alignment layout tab be gray (not usable)? I need to remove a PI and I can't. I can modify it by clicking and dragging it, but I can't use the tools on the layout tool bar. I just had it happen with a profile too. Help!
sinc
2008-01-09, 04:26 PM
Is this a Civil-3D question?

If so, there has been an odd bug that periodically causes that toolbar to become unusable. Shutting down and restarting C3D fixes it. I believe it is still a mystery as to why or when this happens.

The usage of that toolbar is also a little strange. It actually gets "linked" to a profile or alignment when you right-click a profile or alignment and select "Edit geometry". So sometimes you might have it linked to one profile while you are trying to edit another profile. To keep from getting confused, it helps to close that toolbar as soon as you finish editing an alignment or profile, so you always open it fresh whenever you need it.
EECylwik.224738
2011-02-16, 05:13 PM
Is there still no work around / solution other than restarting Civil 3D? I run into this problem pretty often
rkmcswain
2014-08-01, 03:02 PM
It's still an issue in C3D 2015.
ECTNVPE
2017-06-23, 03:28 PM
Still an issue with C3D 2018.
rickquin651723
2021-10-21, 09:50 PM
Still an issue in 2021.
BlackBox
2021-10-22, 11:34 AM
Still an issue in 2021.

And for 2022, FWIW.



Is this a Civil-3D question?

If so, there has been an odd bug that periodically causes that toolbar to become unusable. Shutting down and restarting C3D fixes it. I believe it is still a mystery as to why or when this happens.

The usage of that toolbar is also a little strange. It actually gets "linked" to a profile or alignment when you right-click a profile or alignment and select "Edit geometry". So sometimes you might have it linked to one profile while you are trying to edit another profile. To keep from getting confused, it helps to close that toolbar as soon as you finish editing an alignment or profile, so you always open it fresh whenever you need it.

The only way I've been able to continue - without restarting Civil 3D (and this doesn't always work) - is after the toolbar becomes 'linked to a Profile and no longer works, is to open the toolbar for another Profile (sometimes multiple) before it will 'work' again, then go back to the Profile I was attempting to edit.