ntnik
2008-01-22, 06:56 PM
left - right, up - downwall are exterior walls , in pdf, ( i am tracing over an acad drawing and starting a model). The angle walls are 4" block. I have had this happen before with varying results from the "edit wall joins" tool.....i have usualy "cheated" by holding the interior wall off of the other slightly.
Is there something i'm not understanding about wall properties?....i wish for my 4" block wall to join to the interior face of my exterior wall here.
Is there something i'm not understanding about wall properties?....i wish for my 4" block wall to join to the interior face of my exterior wall here.