"Reference Other View" with section head

[spooner24]

I have a standard section detail that is repeated in a number of locations. Is it possible to drop in a Section head and tail that would reference back to that standard detail? It would act similar to the View-Callout command and checking the "Reference other view" box and selcting the appropriate detail.

If there is no direct solution, does anyone have a workaround to accomplish this same technique?

[Teresa.Martin]

Hi. You have this option when you first create the section. You should see an option on the options bar to reference the other view (detail, another section, etc.).

I hope this helps.
Best regards,

[patricks]

Sections, callouts, and even elevations all have the "Reference Other View" command available, where you can reference a different section, callout, or elevation, or even a drafting view that might be a typical scenario repeated many times.