elaforge
2008-02-18, 08:15 PM
I have posted this in the Revit MEP section of the forum as well. I figure it is worthy of a post in the this forum as well.
I am working on a project that has the Architectural and Structural models linked into the MEP model and when I run an interference check it reports interferences with duct (or other MEP content) and demolished steel. I ran the report from a view that was set up to show Previous + New in the Phase Filter "section of the View Properties dialog box. Does anyone know how I can/should set it up so it doesn't report an interference with a demolished element? Thanks for any help that anyone might offer.
I am working on a project that has the Architectural and Structural models linked into the MEP model and when I run an interference check it reports interferences with duct (or other MEP content) and demolished steel. I ran the report from a view that was set up to show Previous + New in the Phase Filter "section of the View Properties dialog box. Does anyone know how I can/should set it up so it doesn't report an interference with a demolished element? Thanks for any help that anyone might offer.