Level Annotation Draw Order

[annl]

Attached is an image of a common output problem that I've not found a reasonable solution for. The Level annotation lines always are first in draw order -- is there a way to set them back? Setting them transparent does not help in the plot output. The attached example, the level lines are set transparent and gray.

The level annotation dashed line often interferes with elements shown in sections. In the attached example the floor decking is a repeating detail and set to always "Bring to Front", but the level line annotating across the section (see at 29' - 6") still supercededs this and draws on top.

[dhurtubise]

Datum will always show in top. You did the right thing by making the lines grey. Note that you dont have to make those go all the way through your view.

[annl]

Thank you. We'll adjust. It will be good when Revit can do more with the level / datum lines. Appreciate the response.

[c-hawk]

Hmm ... I just recreated this scenario with a level and a brick repeating detail and the detail component's lineweight trumps the level's.

[dhurtubise]

Those are 2D details, not model elements