View Full Version : spline line
wfrst2008
2008-02-22, 05:27 AM
In Revit , I can draw spline line and then use it
as a path for sweep.
But if the spline line is imported from Acad , Revit just can't
detect it , why ?
Fung
In Revit , I can draw spline line and then use it
as a path for sweep.
But if the spline line is imported from Acad , Revit just can't
detect it , why ?
Fung
Autocad spline is different than the spline in Revit. If I’m not mistaken, the Revit spline's control points are not attached on the spline while autocad spline's control points are positioned on the spline. Revit wouldn't be able to translate these control points and maintain the curvature. Technically it is possible, so it is worth submitting it as a wishlist item.
dhurtubise
2008-02-22, 02:11 PM
Since its a spline just draw over it
gbrowne
2008-02-22, 04:48 PM
Or explode it prior to importing..
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.