I don't wanna see these lines

[d.dragov157022]

In a section view in Revit, I have a wall (25cm; substrate; brick), which is seen in projection (not cut), with some structural columns into. The problem is that I've joined their geometry, but the column's contour appears in the section. They lie in the same plane, and should be seen as one object. Can somebody help me with removing the column's contour?

[jeffh]

You can use the line work tool set to use "invisible lines" this will remove the line from this particular view. If the condition is seen in another view you will have to use the linework tool there as well.

[Andre Carvalho]

You can try using the Linework tool and make the lines invisible for that view.

Andre Carvalho

[Andre Carvalho]

You beat me in a few seconds on that, Jeff :)

Andre Carvalho

[rmejia]

They lie in the same plane, and should be seen as one object. Can somebody help me with removing the column's contour?

They have to have the same material finish and be the same structural type for the division line to disappear when joined. Also they have to be exactly aligned, they can't be off for even 1/256".