clovis
2008-03-18, 12:39 PM
Hello,
When I open an old dwg in Acad (mechanical) 2008 the dimensions have no grips anymore ?!?
To resolve the problem I have to assist->format->setup drawing.
The problem, with this command, is that the special settings in some dimensions are lost.
Any (better) solution?
thanks
When I open an old dwg in Acad (mechanical) 2008 the dimensions have no grips anymore ?!?
To resolve the problem I have to assist->format->setup drawing.
The problem, with this command, is that the special settings in some dimensions are lost.
Any (better) solution?
thanks