patricks
2008-03-18, 02:21 PM
Just ran across an odd occurrence in a project. The project has not been relocated yet, and the toposurface is sitting way above the building. The toposurface was created from an imported DWG file. When editing the toposurface, all the points are at the correct elevations (in the 220-240 ft. range above sea level).
However, when any contour label line is placed across any contour line on the surface, every single label reads exactly 200'. This makes no sense whatsoever as the toposurface is obviously not flat, and it appears correct in elevation, section, and 3D views.
However, when any contour label line is placed across any contour line on the surface, every single label reads exactly 200'. This makes no sense whatsoever as the toposurface is obviously not flat, and it appears correct in elevation, section, and 3D views.