Curved Ramps

[caad9]

Hi, I'm attempting to use the boundary tool to make an irregular shaped ramp and when I go to finish the sketch I get this error message "Boundaries (chains of one or more Boundary Lines) must be connected by at least two Riser Lines."

Does anyone have a solution?
Thanks

[dhurtubise]

When using the stair tool Revit needs to see some risers. At least one at the beginning and one at the end.

[Andre Carvalho]

Hi, I'm attempting to use the boundary tool to make an irregular shaped ramp and when I go to finish the sketch I get this error message "Boundaries (chains of one or more Boundary Lines) must be connected by at least two Riser Lines."

Does anyone have a solution?
Thanks

When I had this problem a while ago, I solved that by creating the boundaries of my ramp as a chain of lines. If I stoped the boundary and started over from the middle for instance, it won't work. So try creating your boundaries from the start of the ramp until the end as a chain of lines.

Andre Carvalho