View Full Version : Named Print Set Question
zenomail105021
2008-03-27, 07:11 PM
When in the print dialogue you save View/Sheet set settings by saying yes to: "Do you want to save the settings for use in a future Revit session?" The default dialogue comes up: Name "Set 1". OK, so you accept this. Is there anyway to later delete the "Set 1" or change the View/Sheet settings for "Set 1"?
Bill Maddox
PS Looking forward to 2009!
aaronrumple
2008-03-27, 07:42 PM
Use the save and delete buttons....
Andre Carvalho
2008-03-27, 07:43 PM
Yes. You just go back to the Print dialog box, make sure "Print Range" is "Selected views / sheets and click in "Select".
There, you can Rename, Delete, or mark / unmark sheets and views and save the new configuration again. Selecting Revert will bring your original configuration back.
Andre Carvalho
zenomail105021
2008-03-27, 08:16 PM
Well, thanks so much to both of you. I looked everywhere but there. Happy days.
Bill Maddox
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.