fstafek
2008-04-19, 02:39 PM
Hello everyone,
I'd like to ask if there is any way to control cut pattern of demolished toposurface / either not show it or change apearance...
So far I've created toposurface as existing, than unmodified graded region, some new pads were added. Cut line is overriden in "demo + new" phase filter as dashed, so far so good, but I'm unable to control any way the toposurface demolished cut pattern itself...
Is it a known issue / feature or am I missing something...(RA2009)
Thanks for any info
Best regards Frantisek
I'd like to ask if there is any way to control cut pattern of demolished toposurface / either not show it or change apearance...
So far I've created toposurface as existing, than unmodified graded region, some new pads were added. Cut line is overriden in "demo + new" phase filter as dashed, so far so good, but I'm unable to control any way the toposurface demolished cut pattern itself...
Is it a known issue / feature or am I missing something...(RA2009)
Thanks for any info
Best regards Frantisek