Wall Joins won't work in RAC 2009

[dsw98]

So with 2009 i've noticed my generic models won't join their geometry with walls. Is there a work around?

[Dimitri Harvalias]

I can't reproduce that problem. Is that an in place family and a wall?

[dsw98]

I can't reproduce that problem. Is that an in place family and a wall?

yes it is. It's after I upgraded to 09, many things un-joined and won't re-join.

[dsw98]

yes it is. It's after I upgraded to 09, many things un-joined and won't re-join.


I'm still having major issues on my generic in place families. I join geometry, it joins but the lines that should disapear between a wall and object are still there, defeating the purpose of joining them. Any ideas as to why?

[lev.lipkin]

Can you post simplified model here (wall and family instance, better in r2008 if possible) or send the model to Support? Thanks.

[dsw98]

Can you post simplified model here (wall and family instance, better in r2008 if possible) or send the model to Support? Thanks.

Here ya go. The in place family is the triangle. All the guys in our office are having the same problems with other in place families.

[lev.lipkin]

Thanks a lot. We got problem reproduced and investigating. Sorry for trouble.

[dsw98]

Thanks a lot. We got problem reproduced and investigating. Sorry for trouble.

any update on this problem? It really detracts from my elevations.

[lev.lipkin]

Most likely the problem will be resolved in the next web update, but hard to promise for sure until investigation gets fully done.