mmiles
2008-05-17, 08:42 PM
Hi all,
I have created a profile to use for a wall sweep. It is for a shingle style (sort of) type of house detail. In the case of our design, the sweep inevitably intersects with the rake of our roof. (see picture)
My question is how can I control the end conditions of the sweep. Ideally, the sweep would either join (like roof joins do), or have a chamfer setting of some type to allow me to control different angles for the profile at the ends.
Is there a way to do this using host wall sweeps?
I suppose if it were for an in-place family, I could use voids to cut off the overlapping volumes, but I am trying to avoid using them, currently.
I have created a profile to use for a wall sweep. It is for a shingle style (sort of) type of house detail. In the case of our design, the sweep inevitably intersects with the rake of our roof. (see picture)
My question is how can I control the end conditions of the sweep. Ideally, the sweep would either join (like roof joins do), or have a chamfer setting of some type to allow me to control different angles for the profile at the ends.
Is there a way to do this using host wall sweeps?
I suppose if it were for an in-place family, I could use voids to cut off the overlapping volumes, but I am trying to avoid using them, currently.