PDA

View Full Version : Detail Component Manager



ekohles
2008-05-22, 03:26 PM
The last time I changed the display of the details coming out of the manager
(i.e. changing them between a cross section view, plan view, and elevation view).
I was using ADT 2007 now I’m using Acad MEP 2008
It’s been a while since I’ve done this, and I can’t remember how.
Hopefully it can be done, and hopefully it’s the same way.
Could someone please refresh my memory?

pauljordan
2008-05-22, 04:33 PM
If you were to ask this question in say the Autocad MEP forums, I'll bet you'll get a much faster answer... Perhaps one of our wonderful mods will move it there for you.

dkoch
2008-05-23, 12:51 AM
Use the Properties palette to set the view to the desired type after selecting the desired detail component but before starting to draw.

Steve_Bennett
2008-05-24, 07:58 AM
Wonderful moderator is moving said thread to the DCM forum...