Doug
2008-06-02, 06:04 PM
Two Problems -
I am having a problem with a Topo supplied by my clients engineer. When I import the dwg file into at level 1 all of the line drawing data is approx 445 ft below Level 1 and the 3d Topo is about 430 above Level 1, when you add the 2 together give the right elevation for the project. however the level elevation are wrong in the Revit drawings (off 445 ft).
How do I correct this?
I designed a project using a sketch of just the perimeter of the site with out reguard to the proper northing (word???) of the site.
Naturally the site is about 92 degrees off from the project north as designed... is there anyway I can import the project into a new project that would contain the site data from the engineer (corrected to proper elevation) and the proper orentation
I am having a problem with a Topo supplied by my clients engineer. When I import the dwg file into at level 1 all of the line drawing data is approx 445 ft below Level 1 and the 3d Topo is about 430 above Level 1, when you add the 2 together give the right elevation for the project. however the level elevation are wrong in the Revit drawings (off 445 ft).
How do I correct this?
I designed a project using a sketch of just the perimeter of the site with out reguard to the proper northing (word???) of the site.
Naturally the site is about 92 degrees off from the project north as designed... is there anyway I can import the project into a new project that would contain the site data from the engineer (corrected to proper elevation) and the proper orentation