Curtain Wall Interior Elevation

[andymeyer50]

I am elevating all of our curtain walls throughout our project and finding that when I place those views on our plot sheet, once I activate the view and try to edit the profile of the curtain wall it cannot be done in this view. The only way I can edit the profile is to go to the exterior building elevation. I can't even select the center lines of mullions to reposition them in the interior elevation view. Has anyone had this problem? I have had this happen numerous times in the past but this project every frame is that way it seems like.
Thanks,
Andy

[Scott Womack]

I am elevating all of our curtain walls throughout our project and finding that when I place those views on our plot sheet, once I activate the view and try to edit the profile of the curtain wall it cannot be done in this view. The only way I can edit the profile is to go to the exterior building elevation. I can't even select the center lines of mullions to reposition them in the interior elevation view. Has anyone had this problem? I have had this happen numerous times in the past but this project every frame is that way it seems like.
Thanks,
Andy

Check the settings in the Curtainwall elevations. If you have walls, or certain types of lines turned off, you'll experience the behavior you are seeing.

[ian.nichols]

Have you tried using the Filter tool to select just the Curtain Grids, before trying to adjust the mullions?

Regards,
Ian

[d.stairmand]

Andy
This happens to me all the Time!!
Most probably you have the "Walls" Turned off this the Elevation View.
The Curtain Panels & Mullions Still show up - but the actual "Profile" is located on a Wall.
Fix:
Turn on the Walls in the Visibility & it should allow you to Edit the Profile!