kathy71046
2008-07-02, 05:12 AM
I have a model I am working on, and created toilet drawings to link in as a group.
The walls of the building and the walls on the toilets are seperate so as to stop the ceilings in the toilets having problems if the outer walls move.
Where my toilet inserts to inside a corner, it's fine, but when I try and put it on an outside corner, it insists on making me remove a wall constraint and joins the wall to the toilet.
There is a 10mm gap between the two walls.
Is there a setting to stop this happening?
The walls of the building and the walls on the toilets are seperate so as to stop the ceilings in the toilets having problems if the outer walls move.
Where my toilet inserts to inside a corner, it's fine, but when I try and put it on an outside corner, it insists on making me remove a wall constraint and joins the wall to the toilet.
There is a 10mm gap between the two walls.
Is there a setting to stop this happening?