Toilet Partition

[greg.gebert978266]

I created a wall type for a 3/4" toilet partition. When I draw the wall it automatically joins into the gypsum board. Is there a setting to keep it from jointing into the wall?

[saeborne]

You can right click on the intersection, and "Disallow Join."

That said, I found that it's better to create a component family to represent my Toilet Partitions, as they are not walls per se. I don't want them to cut the same way. I don't want them to have the same line weight.

In the end, our toilet partitions are in the category of Plumbing.

Hope this is helpful,

Bryan

[greg.gebert978266]

You can right click on the intersection, and "Disallow Join"

That worked perfect, thanks!