ace84
2008-07-30, 07:56 PM
Hi
I am trying to create a 7 degree angled wall by ultimately using the Wall By Face of a mass.
I have created my solid mass by selecting the outer edges of my ground level slab and extruding it up 50'.
My south wall and north walls are to be sloped 7 degrees to the north.
My work plane is at ground level for the sketch, I'm not sure if this is relevant.
How can I achieve this using a Cut Extrusion?
Or am I using a totally wrong technique.
Any input is appreciated.
I am trying to create a 7 degree angled wall by ultimately using the Wall By Face of a mass.
I have created my solid mass by selecting the outer edges of my ground level slab and extruding it up 50'.
My south wall and north walls are to be sloped 7 degrees to the north.
My work plane is at ground level for the sketch, I'm not sure if this is relevant.
How can I achieve this using a Cut Extrusion?
Or am I using a totally wrong technique.
Any input is appreciated.