Can I edit RC beams joint?

[thetlin24]

I'd like to ask that how can we edit joint between two defferent width of beams in Revit.

Thanks for ur helps
thetlin24
Structural Drafter

[Steve Mintz]

What's the context for this condition? How would you like it to clean up? I can't help but notice one of your beams is significantly wider than the column. Are these grade beams?

[thetlin24]

What's the context for this condition? How would you like it to clean up? I can't help but notice one of your beams is significantly wider than the column. Are these grade beams?

Hi!
Thank's for your reply.
Actually, one of my beam is wider than the column and the rest beam.
Because my wider beam is actually Transfer beam.
My point is that, when other narrower beam comes and joins as shown,
I want them to be as Union (Auto CAD) and edit.
I don't want to fillet like that.
Structurally also beam cannot sit partially on the column like that right?
So, I want to customize RC Beam Joint like beam edit command for steel.

I've got one solution is that I'll have to put one cantilever beam continuous with wider beam.
Pls advise me somethings.

Thanks

Thet Lin
Structural Drafter