PDA

View Full Version : sub topo shadow/shading problem



soender
2008-08-22, 08:05 AM
Hi :)

I´m doing my Elevations with shadows. I would think that the "Ground Plane at Level", under Sun and shadow settings, set to the level just above the topo surface, would stop the shadow here. Instead, the shading is castet below the surface, and gives a wrong perception of depth.. I have tried to move the "ground plane at level", set level, both up to the roof level, and down to the foundation level, without any change in the shadows castet.

Does anyone have a solution to this?

regards, troels

Andre Carvalho
2008-08-22, 01:53 PM
You can try using two views: One with no shadows and cropped from the toposurface level down. The other view with shadows on and cropped from the toposurface up. The insert both on top of each other in the sheet.

Andre Carvalho