View Full Version : Compress a section detail
Kenny Gee
2008-09-04, 06:35 AM
I cant figure out how to remove larger middle section/s of a piece of joinery (in section). See attached Autocad drawing showing the use of cut lines to compact the section (I know how to do these cut lines in Revit – I’m not that much of a newbie). The only way I can think of doing it is to create two sections, then place them ontop of 1another on a sheet.
There has to be an easier way to create a compact section of tall items????
Kenny Gee
2008-09-04, 06:42 AM
never mind
I know how to do it now. Stupid me
kathy71046
2008-09-05, 12:30 AM
Want to share for those who might find themselves in the same situation in the future?
Kenny Gee
2008-09-05, 12:42 AM
see attached
mcloer
2008-09-05, 03:54 AM
No BLACK background....... :(
Kenny Gee
2008-09-05, 04:35 AM
?????????????
Jun Austria
2008-09-05, 06:27 AM
No BLACK background....... :(
Its a hard habit to break after using AutoCAD for almost two decades. But after using Revit seriously for 3 months, I totally forgotten AutoCAD. But it make my hair stand when people aske me "Can you do this in AutoCAD?". :-)
kathy71046
2008-09-05, 06:48 AM
Thanks Kmannix,
I'm sure that will come in handy in the years to come....now if I can just get the robobat stuff to do the same.....
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.