Pipe Inverts at Structure Wrong Location on Split Profile

[dmanning]

Does anyone know how to get split profiles to display inverts at structures properly? Look at the attached drawing to see the issue.
The deal is that everything draws correctly but when I adjust the datum of a section of the split profile the structure pipe outlines adjust the same amount. This sure will be a pain if it doesn't work correctly.

[dmanning]

Engineered Efficiency is my reseller and offer great support on technical issues. They have been unable to figure this out and it is being turned over to Autodesk to see what they can tell us.

Would one of you recreate this situation and tell me what you experience? Create a pipe run and draw it in profile view. Edit the profile view to have a split and adjust the datum by 10 feet or so. Zoom to a structure that has multiple inverts and see what happens to the invert at the structure.

Any suggestions would be greatly appreciated.