Sloping Site Section

[Phillip_Miller]

When cutting a cross section is there anyway of having a sloping site behind being turned of. ie the building is showing the cut and the projection in the distatnce of all the walls etc, but the site only showing where it is being cut.

Cheers

Phillip

[brenehan]

Yes and no. It does depend how complex the section is.
Easy solution is in VG set the topography projection lines to white.
However if you want to show where the site meets the building in elevation this method may be problematic.

[Andre Carvalho]

Also, depending on how deep you want to show your section you could set your section depth to be very small.

Andre Carvalho

[sbrown]

Just go to the view properties of the view and change your Far Clip to 1/8"