Roof Fascia?

[aliya14]

Good day everyone!
I wanted to know about the roof fascia problem i am facing, I have created a fascia profile using the fascia family but when i load it in my drawing and when i go to place the fascia using host sweep - roof fascia choosing my profile of fascia i place the fascia on the roof with 2 sides defined with the slope and the other 2 sides r not defined ,the edged don't align with each other.what can be done to solve this..
regards,
Aliya

[beegee]

What happens in Revit using host sweep for fasia, and in practice, is that there is a short horizontal return of the fasia before the rake begins.

Is that what you are seeing ?

[aliya14]

hello,
I meant i am not able to align the face of the fascia with the other face of the fascia.
thanx
Aliya

[Mr Spot]

Parts of the fascia that are on different plane will not automatically trim together with this type of geometry.

What i've typically done to work around this is to create a special corner element to the gutter...

[Scott M.]

Try Making your roof with square rafters instead of plumb. Then delete and redo the facia sweep

[aliya14]

Thanx to all of you ,Gr8888888 I din't know that it was that simple ,& simply wasted so much time finding out the solution myself i should have asked u earlier.
Regards,
Aliya