Curve Wall hatch pattern

[matt.orsillo]

I have created a curved CMU wall but am unable to edit the hatch pattern (moving the pattern lines to line up with the edges). I can move the the horizontal lines up and down, but i cannot move the vertical lines side to side. Is there a way to edit the vertical lines of a hatch pattern of a curve wall?

[Andre Carvalho]

In an elevation view or 3D view, hit tab until you can select the vertical pattern line. If you keep holding the mouse button, you can drag it sideways. Not accurate as the align tool but works.

Andre Carvalho

[mostafa90]

this doesn't work is there some other ways to align the vertical hatch

[eric.piotrowicz]

Go to an elevation and use TAB to pick the vertical line then switch to a plan view. Use the rotate tool to reposition the pattern. The accuracy of this is going to depend on drafting out your mortar joints, both where they are by default and where you want them to go. Its best to draw a ref plane at a joint that is as close to perpendicular to the elevation as possible so you have an accurate point of reference in plan.