Eric Stewart
2003-08-14, 01:10 PM
So, is this the new hangout? Not much is going on over at alt.cad.revit.
This is for an addition/remodel job.
I would like to use a filled region to designate an area of an existing plan that is not to be modified. However, when I place the filled region it obsures the model objects (walls, doors etc.). I tried to "Send to Back" the region but that did not help.
Is there anything I can do?
Thanks.
Eric Stewart
This is for an addition/remodel job.
I would like to use a filled region to designate an area of an existing plan that is not to be modified. However, when I place the filled region it obsures the model objects (walls, doors etc.). I tried to "Send to Back" the region but that did not help.
Is there anything I can do?
Thanks.
Eric Stewart