P-trap as elbow

[truevis]

Attached.

Take a coplanar vertical pipe and a horizontal pipe. Trim-corner them, picking the vertical pipe first. Replace the elbow with this family (P-Trap - PVC (elbow).rfa) and there you have it.

[jason.combs]

Awesome and thanks.

I was able to click on the + and - of the fitting to eventually get the P-trap oriented correctly if the riser line was selected last using the trim command. The trap first is incorrect, then changes to a tee, then an elbow, then I reselect the P-trap.

Doing this, rather than delete and reinserting keeps the system connected.

Regards,

[staceyconrad]

Thanks Man. I created the exact same family at a previous employer, and was very excited to find that I didn't have to spend the time to create again. Many thanks.

[jon.kaminski]

have you experimented with a "plan view" version of this?


Attached.

Take a coplanar vertical pipe and a horizontal pipe. Trim-corner them, picking the vertical pipe first. Replace the elbow with this family (P-Trap - PVC (elbow).rfa) and there you have it.