Horizontal Mullion Join at Corner

[aleksandar.dimitric]

I can't get two horizontal mullions in the image to join correctly. The problem is that the upper part of the mullions differs. If I use the same profile Revit does it correctly. Is there any way to trim the unnecessary mullion part created in the third image? Thanks!

[kpaxton]

aleksandar,

First of all, Welcome to AUGI !! Your question is - Can I get Revit to 'trim' the mullions when there are 'extras' or if it uses two different profiles? Unfortunately, No - not when the mullions are of two differing profiles/shapes and not when you're using the standard mullion tool. Revit treats these mullions as a simple sweep, using the Profiles along a path of the gridline, and the geometry simply doesn't match-up.

In oder to do specialty mullions and shapes (in your example), you'd actually need to create a special corner 'Panel', and create the geometry for the mullions inside. Hope this helps.

Kyle

[aleksandar.dimitric]

Thanks Kyle, saved me a lot of time and trouble.
I'll try doing it with the corner panel.