DaveP
2008-11-26, 03:48 PM
Is there a way I can set a default for a Project Parameter?
I'm adding a parameter called NIC for later use as a Filter.
When you insert a family that uses NIC, it shows the NIC parameter as greyed out, but checked. Once you click on the parameter, it changes so it's not greyed out, and you can check
or uncheck it.
I understand the difference between Checked, Unchecked, and Not Set, but I'm afraid some of my - shall we say - less experienced people will see the grey box with a check in it and think that means checked. I'd just like the Not Set default to not have a check in it.
I'm adding a parameter called NIC for later use as a Filter.
When you insert a family that uses NIC, it shows the NIC parameter as greyed out, but checked. Once you click on the parameter, it changes so it's not greyed out, and you can check
or uncheck it.
I understand the difference between Checked, Unchecked, and Not Set, but I'm afraid some of my - shall we say - less experienced people will see the grey box with a check in it and think that means checked. I'd just like the Not Set default to not have a check in it.