sweep profile always vertical

[steedlei]

Is there any way to not let sweep profile perpendicular to sweep path and always stay vertical? Thanks!

[Carlos GT]

I don't think you could do that. The profile always will run perpendicular to the path.
What kind of solid are you trying to create?

[dhurtubise]

Unfortunately not in Revit

[steedlei]

thanks for the confirmation. I try to create ledger along the interior edge of tilt-up concrete wall. Now tf the path of sweep is not horizontal, the profile of cut section of ledger will be slightly off the right dimension. I may have to use detail component to correct it in section.