Stairs - Not Modelling up Correctly

[d.stairmand]

I have this Stair, a Monolithic, that doesn't Model Up Correctly. The Bottom Flight of Stairs doesn't have a Parallel Back to it - It Splays out. I have tried this on our company template & a Fresh Blank Metric one as well - & it still generates this Error. If the Landing is Smaller or Bigger than 900 - Its OK!

Firstly - has anybody else encountered this Issue?
Secondly - Any Suggestions on how to Fix this?

[eddy.lermytte]

Dwane

Try this;
go to System Rfa of your stair > Risers > uncheck "Begin with Riser"

[fernando]

The problem as to do with the automatic stair generation, the solution you pretend is not possible to do with automatic stair generation aplication, the underside of the stair is always paralel to the stair run, when you change a thread dimension it slant the stair underside. No solution except do a inplace stair.

[patricks]

Dwane

Try this;
go to System Rfa of your stair > Risers > uncheck "Begin with Riser"

A monolithic stair must begin with riser and end with tread - always.

[d.stairmand]

Thanks Guys for the Reply's
Good to Know I'm not going Mad! Its a real Pain - as it only happens for the 900 Landing - Bigger or Smaller It works out Ok

[dhurtubise]

Dont forget to submit to support :-)