Generic Model Floor Based on Sloped Floors

[dvemis]

Here's my problem. I have a base slab (floor) sloped top and bottom and I need to place isolated thickenings with constant depth (200 mm) at the location of the columns.Because of the slopes my generic model floor based is not connected to the floor. Any ideas on how to build my sloped floor with these isolated thickenings?Thanks

[aggockel50321]

Try opening your generic model family, Then go to settings / Family Categories and Parameters, and ucheck the "always vertical" checkbox at the bottom of the dialog. Save and reload the family, and see if it follows the sloped slab.

[dvemis]

I am still have difficulties. It looks that once I define the slopes for the floor I can't apply any face based model to the element.Thanks for reply.