McMansion "sweep" issue

[ntnik]

i have had issues with sweeps but never this one...in most all the watertable sweep does NOT join at corner........suggestions???

[cliff collins]

Try mitering the walls in plan view with the wall join tool.

cheers....

[ntnik]

ok ....will try that......another thing though.......i had modified the regions in the wall assembly and stretched the brick and the air gap down.......does that have any affect on a sweep?

[cliff collins]

If you just "pulled the brick and airspaces" vertically in the wall structure section edit
tool, and if the (2) walls are the same type, then they should join properly at corners.

If you edited on wall style, and not another, then tried to join you might have problems.

cheers....

[ntnik]

wait.....sweep was outside parameters.......went back to profile and lowered the profile.....works fine now