align command

[reemino]

I am trying to align a raster image with a dwg drawing. I used two source and two destination points and chose "yes" for scaling and alignment. But the result is not impressive. My image is not aligned. Could some one help.

Thank you
Reemino

[rkmcswain]

What program are you using and what command?
Do you have Map and/or Raster Design?

[scott.wilcox]

I am trying to align a raster image with a dwg drawing. I used two source and two destination points and chose "yes" for scaling and alignment. But the result is not impressive. My image is not aligned. Could some one help.

Thank you
Reemino

Perhaps your destination points were on different elevations (z values). This would distort the image file in the viewing plane.

[Maverick91]

I am trying to align a raster image with a dwg drawing. I used two source and two destination points and chose "yes" for scaling and alignment. But the result is not impressive. My image is not aligned. Could some one help.

Thank you
Reemino
I do this a lot, using MAP, ACAD, LDT, and C3D. From what you wrote, it seems your doing it right. Are you trying to align the image to drawing entities, or the entities (lines, arc, circles, etc.) to the image?