Adjust Patterns On Curved Walls

[DO-PRE]

Is there any way of doing this. I have a curved block wall but i can only adjust the pattern in one direction. Any help would be great.

Thanks,.

Dan

[Andre Carvalho]

First, make sure the option Press + Drag is checked in the options bar. Then, in an elevation view select one vertical line from the pattern by using the TAB key, select the line, press and drag the line sideways (away). You can't make it accurate but at least will get close. If you hold Shift, then you can constrain it to keep the vertical alignement.

Andre Carvalho

[DO-PRE]

Thanks Andre, it worked well, except that its not that sensitive...I had to move it 10 to 15 feet away from where I selected the pattern. Is that normal?

[Andre Carvalho]

Thanks Andre, it worked well, except that its not that sensitive...I had to move it 10 to 15 feet away from where I selected the pattern. Is that normal?

Yes it is normal. Usually I move it far away and then bring it back to where I want...

Andre Carvalho